#Report
#header
#len rot force temp e_force e_len ma_force ma_len wd_force den_len prop_len
#disp rot force force_len stress_force stress_len
#comment: 0=in,1=ft,2=mm,3=cm,4=m, 20=yard, 5=lb,6=kip,7=T,8=kgf,9=N, 21=MN
#comment: 10=KN,11=MT,12=rad,13=deg,14=F,15=C,16=Sg,17=kg
#comment: If flag in ~SETUP = 0, this portion only for output file
~UNITS
1 13 6 14 6 0 6 0 5 1 0             
0 13 6 1 6 0             
#
#
#
#
#header
#proj_path_name
#user_name
#job_id_description (50 chars max )
#run_id_description (50 chars max )
# print_headings top_margin lines_per_page turn_ff_off print_banner printer_type
#   print_heading=1 to print headings 0=NO
#   top_margin = number of lines to feed before printing usually 0
#   lines_per_page  usually = 55
#   turn_ff_off = turn initial form feed off usually 1= YES 0=NO
#   print_banner = printer banner separator usually = 0=NO 1=YES
#   printer_type = 0=wide carriage 1=HP 2=EPSON 3=Okidata
#Transaction file Unit flag: 0-use internal default units; 1-use unit set in ~UNIT 
~SETUP
c:\dwgs\
IntelliCAD User
allowable loads
Eagle Point Frame Analysis & Design
1 0 55 1 0 1 
0
#
#
#
#
#header
#outfile echo prn_report reband restart save_stiff anlytype
#cases_to_print
#combinations_to_print
#envelopes_to_print
#if anatype = 2
#  pdelta_only axial_effect tol min_stif power cycle start stop
#if anatype = 3
#   modes_num cut_off prn_modes
#disp_list1-4 (4 lines (each <= 63 chars))
#reacts_list1-4 (4 lines (each <= 63 chars))
#forces_list1-5 (5 lines (each <= 61 chars))
~OPTION
c:\dwgs\allowable.out N R N N N 1

1





1,41








#header
#rec group type(1=max forces full,2=summary by element,
#3=Sum by component,4=full report within range,
#5= Summary by component within range
#elemlist(<=63 chars)
#if type = 4,5 (Full Report within Range or worst 
# amin amx smin smax mmin mmax tmin tmax
#else if type = 6 (axial force past limit)
# compression tension
#else if type = 7 (print at increments)
# number of increments along span (always use 20)
~REPORT
1 3 1
1-79
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
